Soudal MS-30 Plus Adhesive
- Our Price
- £84.50+VAT each (£101.40)
(£101.40 inc. VAT)
The Soudal MS-30 Plus Adhesive is a superior quality trowellable, hybrid polymer based adhesive which has been designed for the glueing of wooden floors to interior subfloors.
With very low emissions the Soudal conforms to EC-1R Plus label.
Single component product, meaning that no mixing is required.
Very rapid cure and strength build up with load bearing after just 3 hours, and sandable after 16 hours.
The Soudal MS-30 Plus is suitable for bonding all types of wooden floors; solid, stab, pre-finished, on-end parquet, wood-plank and wood-block.
MS-30 Plus can be used on both porous and non-porous substrates; anhydrite, concrete, screeds, wood, chipboard, OSB board and floors with underfloor heating.
Technical data
Hybrid polymer trowellable parquet adhesive
Ready to use, single component, low odour
Solvent, isocyanate and water free - 100% solids content
EC-1R PLUS label: very low emission
Load bearing - 3 hours
Sandable - 16 hours
High final bond strength - more than 2N/mm2
Suitable for underfloor heating
Application
MS-30 Plus should be acclimatised to room temperature before installation.
Apply the adhesive to the subfloor by means of a notched trowel. We recommend our 6mm V-Notch Trowel.
Do not apply more than can be covered within 30 minutes.
Slide the wood flooring onto the adhesive layer and tap into place.
A minimum of 80% contact coverage is required to ensure a perfect adhesion. Loading the oak boards with weights will improve the final bond strength.
Wait at least 16 hours before sanding and finishing the floor.
Recommended 6mm V Notch Trowel
More Information
Introduction Ever wondered how to fit an oak floor? With this in mind we have created this handy guide showing the different stages of one of our recent installations. Throughout this guide we have enlisted the help of one of our highly skilled floor fitters, as he shares some of his helpful tips and tricks from his experience in the trade. ( To download a printable pdf version of this guide, click here ) Glueing Method In this particular floor fit, the Hakwood Bonneval engineered oak boards were fitted by glueing them to the sub-floor, which had an underfloor heating system already installed. To make things extra tricky, one side of our room had a plastered wall which would eventually have skirting running along it. On the other side, there was a pointed stone wall, where the flooring needed to run clean up to the edge of the wall, and would therefore require some scribing. A timber frame...
Related Products
Great Service
We'll hand select your oak floor to make sure it's right for you.
Great Quality
European-sourced oak from
managed forests - ALWAYS
Great Value
The floor of your dreams at a price to suit you.
